Standard Test Method for Copper Strip Corrosion by Liquefied Petroleum (LP) Gases

Standard Test Method for Copper Strip Corrosion by Liquefied Petroleum (LP) Gases

Gasoline

Testing

International trade

Copper corrosion

Timing circuits

Scope: This test method covers the detection of the presence of components in liquefied petroleum gases which can be corrosive to copper. Note 1:For an equivalent copper strip test applicable to less volatile petroleum products, see Test Method D130. The values stated in SI units are to be regarded as standard. 1.ExceptionThe values given in parentheses are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 7.1, 10.3.1, and Annex A1. This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. 2021 ASTM International. All rights reserved.

5.01

2021

journalArticle

10.1520/D1838-21

http://dx.doi.org/10.1520/D1838-21